JZ Microphones BH2 Black Hole SE Condenser Mic
Accessories not included

The JZ Microphones BH2 Black Hole SE Condenser Mic is a cardioid condenser microphone with one large, true electrostatic capsule inside the compact head, made with JZ's own Golden Drops technogloy.  This special capsule has a single, less centre tap diaphragm and patterned variable sputtering, using a specially mixed alloy for coating.

The JZ Microphones BH2 Black Hole SE Condenser Mic is  manufactured with the same quality and design as the original Black Hole, with a new generation integrated shockmount.

JZ Microphones BH2 Black Hole SE Condenser Mic Specifications:
-Transducer type electrostatic
-Operating principal pressure gradient
-Diaphragms active diameter 27 mm
-Frequency range 20 Hz to 20 kHz
-Polar pattern Cardioid
-Output impedance 50 ohms
-Rated load impedance >100 ohms
-Suggested load impedance >250 ohms
-Sensitivity at 1000 Hz into 1000 ohms load 21 mV/Pa
-S/N Ratio CCIR 468-3 weighted 76,5 dB
-S/N Ratio DIN/IEC 651 A-weighted 87,5 db-A
-Equivalent noise level DIN/IEC A-weighted 6,5 dB-A
-Maximum SPL for 0.5% THD at 1000 ohm load 134,5 dB
-Dynamic range of the microphone preamplifier 128 db
-Phantom powering voltage on pins 2 & 3 of XLR +48 V (+/-4 V
-Current consumption 1,5 mA
-Output connector 3-pin XLR male, gold plated contacts
-Signal polarity positive toward pressure on a frontal diaphragm produces positive polarity voltage on XLR pin #2 relatively to pin #3
-Dimensions 203 x 51 x 28
-Stand holder and wooden box included